Legrand WKD ProSeries Underfloor Duct Fiber Loop Kit Installation - Manual

Flush Carpet Plates
Cat. Nos. 428 and 433 Series
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 000 206 R2 – Updated June 2007
1. If preset is not exposed, see instructions on page two
for concrete, mudcap and knockout removal.
2. Install link strap using the enclosed self tapping
screws to posts in preset as shown in diagram.
Heads of screws should be slightly below
concrete pour level.
3. Install UL Listed devices if needed to adapter
plate. For Catalog No. 428DR or 428DR2,
receptacle screws must be removed. Use
screws from hardware
bag to attach receptacle to plate.
4. Adjust screws until adapter plates are flush with
finished floor.
5. Secure adapter plate to link straps using (2) #10 x
3/4 flat head screws.
NOTE: To maintain proper ground continuity, tighten
screws to a minimum 10 inch pounds.
6. For 433 Series attach cover plate to duplex
receptacle.
7. For 428B525 attach base plate of service fittings to
adapter plate.
Cat. No. 428DR or 428DR2 (Shown) Cat. No.433DR or 433DR2 (Shown) Cat. No. 428B525
Cat. No. 428B075
#10 Flat
Head Screw
Adapter
Plate
Link
Strap
Cat. No.428BL
Wiremold / Legrand electrical systems conform to and should
be properly grounded in compliance with requirements of
the current National Electrical Code or codes administered by
local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold / Legrand
electrical products may bear the mark as UL Listed and/or
Classified and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.