Legrand WKD ProSeries Underfloor Duct Flush Carpet - Manual

Duct Opening Reducer
No. 4 Duct to No. 2 Duct
Cat. No. 275SR/275SL
INSTALLATION
INSTRUCTIONS
Walker ® electrical systems conform to and should
be properly grounded in compliance with require-
ments of the current National Electrical Code or
codes administered by local authorities.
All electrical products may represent a possible
shock or fire hazard if improperly installed or
used. Walker electrical products may bear the
mark as UL Listed and/or Classified and should
be installed in conformance with current local
and/or the National Electrical Code.
1.
Position adaptor
at angle
shown relative
to opening.
2. Insert end of narrow
leg into box opening
and rotate part
toward opening.
3.
Complete installation
by striking part until
fully inserted
into opening.
4. Install duct step
utilizing the
double backed
adhesive tape.
5.
Insert No. 2 duct
into opening until
end of duct is
against duct stop.
6. Insert legs of ground clip
into the triple slot opening
and drive in with a hammer
until fully seated in place.
Walker Systems, Inc.
A Wiremold Company, Williamstown, WV 26187
IB0173 997 ©1997 The Wiremold Company
Ground Clip
No. 2
Duct Step
No. 4
Duct Opening
Duct Stop Edge
Strike This End
With a Hammer
Duct Spacer
No. 2 Duct
Insert This
End First
NOTE: No. 275SR Adaptor Shown.
No. 275SL Adaptor is Mirror Image
Triple Slot Opening
Grooved Slot