Legrand WKD ProSeries Underfloor Duct Preset Adapter - Manual

Products Covered:
S20ADP1 and S20ADP2
1. Using a flathead screwdriver or chisel,
remove all excess concrete from the
bottom of the preset (see Figure 1).
2. Align adaptor with the top opening
of the preset (see Figure 2).
3. Using a hammer and a screwdriver
tap the adapter until it sits flush with
the bottom of the preset.Do not trap
ground wire below adaptor (see
Figure 3).
4. Place trim flange over adaptor and align
the four mounting holes in the flange to
the four tapped holes in the adapter
(see Figure 4).
5. Tighten flange to adaptor using a
screwdriver. Do not over tighten
flange. Tighten until flange is snug to
carpet or tile surface (see Figure 5).
W
ALKER
I
NFLOOR
S
YSTEMS ®
S20ADP1 and S20ADP2
Preset Adapter
INSTALLATION INSTRUCTIONS
Walker ® electrical systems conform to and should
be properly grounded in compliance with require-
ments of the current National Electrical Code or
codes administered by local authorities.
All electrical products may present a possible
shock or fire hazard if improperly installed or
used. Walker electrical products may bear the
mark as UL Listed and/or Classified and should
be installed in conformance with current local
and/or the National Electrical Code.
Walker Systems, Inc.
A Wiremold Company, Williamstown, WV 26187
1 000 433 999
Figure 1
Figure 3
Figure 5
Figure 2
Figure 4
© Copyright 1999 The Wiremold Company All Rights Reserved