Legrand WKD Infloor Systems Trim Plates - Manual

For Presets with Activation:
1. Remove activation and all unused wire or cable.
2. If previously installed activation has link straps already installed, they can
be used to attach trim plate. (Save new link straps for future activation).
3. Attach trim plate to preset link straps so that plate is flush with top of
carpet floor.
For Presets without Activation:
1. Carpet installer shall carefully cut a 4 1/2" x 5" [114mm x 127mm] (single), or
5" x 9" [127mm x 229mm] (dual) cut out centered over preset, using a suitable
template. Save carpet cutout for future abandoning.
2. See page two for concrete, mudcap and knockout removal.
3. Secure link straps to post on preset. Mount plate to straps with screws.
4. For plates with conduit openings: Install connectors making splice in preset
before attaching trim plate.
5. For plates with tabs for 505 fittings: Slide housing over tabs and assemble as shown in diagram.
NOTE: Base plate of 505 fitting not used.
Trim Plates
Cat. Nos. 430, 431 and 432 Series
INSTALLATION INSTRUCTIONS
Walker ® electrical systems conform to and should
be properly grounded in compliance with require-
ments of the current National Electrical Code or
codes administered by local authorities.
All electrical products may represent a possible
shock or fire hazard if improperly installed or used.
Walker electrical products bear the mark as UL
Listed and/or Classified and should be installed in
conformance with current local and/or the National
Electrical Code.
Cat. No. 430AL075 and 430BR075 (with
Conduit Opening. Cat. Nos. 430AL and
430BR (Blank) Similar.
Cat. Nos. 432AL and 432BR
Cat. No. 431AL075 and 431BR075 (with conduit open-
ings). Cat. Nos. 431AL and 431BR (Blank) Similar.
Cat. Nos. 430S505 and 431D505 (Shown)
505 Series
Order Separately
Link Strap 97651
Link
Strap
97650A