Legrand WC Cellular Raceway Grommet - Manual

1. Slide the two tabs on one side of the
grommet into place below the edge
of the opening.
2. Squeeze the second side to allow the
tabs to snap into place below the other
edge of the opening.
NOTES:
1. Grommet must be in place before installation of
telecommunication cables.
2. Not intended to provide the required bend radius
for telecommunication cables.
3. Not for use with power applications.
Figure 1
Figure 2
Figure 4
Figure 3
Figure 5
WCR/WDR Grommet
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 000 674R1 – Updated March 2010
Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold electrical products
may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
Wiremold
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
1 000 674R1 0310 © Copyright 2010 Legrand/Wiremold All Rights Reserved