Legrand WC PK Preset Activation Kit - Manual

Products Covered: WPACR, PKGRBR, and DTB Communication Brackets
Preset Location:
1. Determine location of preset cover by measuring (when layout is known)
or by using an electronic preset finder.
2. Cut or remove floor covering over preset location.
3. Using a hammer, remove the concrete from mudcap cover.
4. Remove the mudcap by hitting the center of the cap until the sides are deformed.
5. Insert a screwdriver along the edge of the cap and pry up.
6. Remove any debris that may have fallen into the preset opening.
Power Installation:
1 . Remove knockout from power compartment. Grommets must be installed prior
to pulling cables and before internal components are installed to prevent damage
to cables.
2. Place one side of the two-piece grommet over the power opening and squeeze
until it snaps into place. Repeat for the other piece of the grommet.
3. Install the second set of grommets if activating both sides of the preset with power.
4. Pull the electrical wires through the grommeted openings in the center cell.
5. Attach electrical conductors to the UL Listed duplex receptacle(s).
Make sure that any ground leads are connected to ground screws.
6. Attach the receptacle insulator and receptacle to the receptacle mounting bracket
using #6 screw provided. Attach the receptacle to the receptacle mounting bracket
with two additional screws and nuts (not provided). Attach the outlet box cover to
the preset using two #10 mounting screws provided.
PK Preset Activation Kit
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 002 300R1 – Updated March 2010
Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold electrical products
may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
IMPORTANT: Please read all instructions
before beginning.