Legrand 2000 Series Aluminum Plugmold Multioutlet System - Manual (Page 2)

AL2010A Feed End Fitting
AL2010B Blank End Fitting AL2043 In-line Receptacle
AL2043TR Tamper-Resistant In-line Receptacle
AL2043IG In-line Isolated Ground Receptacle
AL2043TR-IG Tamper-Resistant In-line
Isolated Ground Receptacle AL2040A In-line Single Pole Switch
For AL2043 Series Two 15A, 120V U-ground factory prewired
receptacles. To install slide coupler into grooves of AL2000B
end base raceway and push sections together. Connect
wires, tighten. Screws and snap in cover.
At end of AL2000B base raceway run, slide AL2000A or
AL2000B fitting in last base section. Secure in place by
tightening screw.
For AL2043IG Series Two 15A, 120V Isolated ground factory
prewired receptacles. To install slide coupler into grooves
of AL2000B base raceway and push sections together.
Connect wires, tighten screws and snap in cover.
Single Pole Switch 15A. 120V. To Install slide coupler into
groove of AL2400B base raceway and push sections together.
Tighten screws and snap in cover.
AL2003 Mounting Clip AL2006 Cover Clip
To close any gaps. That occur from field cutting, snap
AL2006 Cover Clip over joints, where two adjoining
pieces come together. Use for external support of raceway. To install attach
AL2003 to mounting surface with screws. Snap
raceway base into AL2003.
AL2000 RACEWAY WIRE FILL CAPACITIES FOR POWER
WIRE TYPE THHN/THWN
POWER WIRING 10 AWG 8
WITHOUT DEVICE 12 AWG 12
1.1 sq. in. cross section 14 AWG 24
POWER WIRING AWG 10 AWG 3
WITH DEVICE 12 AWG 6
515 amp devices 14 AWG 8
.8 sq. in. cross section
NOTE: Raceway may be configured in single or
multiple channels to accommodate power
or communications wiring.
MAXIMUM CROSS SECTION
1.1 sq. in.
[27mm]
1 7/16"
[37mm]
1 1/8"
[29mm]
.8 sq. in.
[20.3mm]
AL2000 RACEWAY WIRE FILL CAPACITIES FOR POWER