Legrand PCIQ PDU-TS1 Temperature Sensor - Manual

Wiremold / Legrand electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold / Legrand electrical
products may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
PDU-TS1 Temperature Sensor
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 007 726 – April 2008
IMPORTANT: Please read all instructions
before beginning.
Connecting the Sensor:
The only operation needed to install and operate the temperature sensor is to connect its jack into
the “sensor port” on to the Wiremold smart PDU product. We suggest locating the probe to the
hottest known location within the cabinet.
Wiremold / Legrand
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
1 007 726 0408
© Copyright 2008 Wiremold / Legrand All Rights Reserved
Temperature probe
connection to Power
Commander IQ series.
Products Covered: SPDU20-0U, SPDU8-1U, SPDU16-2U
NOTE: Using the sensor with any other than mentioned products might damage sensor and/or equipment to which it
is connected.