Legrand TS TableSource Work Surface Modules Installation - Manual

TableSource ™
Work Surface Modules
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 42073R1 – Updated December 2011
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
NOTE: Use No. 8 (5/16" [7.9mm] head size) flat head fastener or equivalent
to secure mounting clip onto table surface (top or bottom).
INSTALLATION:
REMOVAL: