Legrand Evolution Series Work Surface Portal - Manual

Evolution Series ™
Work Surface Portal
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 008 956 – December 2009
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
SURFACE INSTALLATION:
Step 1. Using a jigsaw and the template provided, cut a
circular opening in the table.
WS6S –
6 1/4" [159mm] diameter
WS8S – 8 1/4" [210mm] diameter
Step 2. Insert Evolution Series Work Surface Portal into
opening in the table, and orient as desired.
Products: WS6F, WS6S, WS8F, WS8S
FLUSH INSTALLATION:
Step 1. Using a router with a 1/2" [12.7mm] straight cutting bit
and a circle cutting jig, rout a circular pocket based on
the dimensions shown below.
WSF6
WSF8
6 1/4"
[159mm]
7 1/4"
[184mm]
5/32"
[4.0mm]
8 1/4"
[210mm]
9 1/4"
[235mm]
5/32"
[4.0mm]
CAUTION: The 3-prong, grounding type plugs in all units are for use with 3-prong, grounded receptacles only.
Modifying or bypassing the ground pin for use in a non-grounded receptacle may lead to electrical shock,
and voids the product warranty. All units are designed for interior use in dry locations only.