Legrand TPP-E - Manual

Tele-Power ® Pole Extenders
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 008 996 – April 2010
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
Package includes: one (1) 25DTC-E5 5' [1.525m]
Tele-Power Pole Extender.
FOR EXTENSIONS OF 25DTP-4 SERIES TELE-POWER POLES
1. Line up Tele-Power Pole Extender with top of 25DTP-4
Tele-Power Pole with the longer sleeve on the same side
as the 8" [203mm] top cover of the existing pole.
2. Remove the 8" [203mm] cover from the top of 25DTP-4
Tele-Power Pole.
3. Make any needed wiring connections per NEC codes.
4. Slide TPP Extender into 25DTP-4 Tele-Power Pole. 5. Tighten coupling hold-down screw.
6. Replace 8" [203mm] cover. Finished assembly. Complete installation using 25 Series
Pole installation instructions and fill capacity information.
NOTE: No more than two connections (three sections) per pole.
PRODUCTS COVERED: 25DTC-E5, 25DTP-E10, 25DTC-E10
Sleeves
Sleeve