Legrand ALTP-2 Series Pole - Manual (Page 2)

The Wiremold Company
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
850 Gartshore Street • Fergus, Ontario N1M 2W8
1-800-741-7957 • FAX 519-843-5980
42510R1 – Updated May 2004 – For latest specs visit www.wiremold.com
© Copyright 2004 The Wiremold Company All Rights Reserved
Step 1 Remove cover. Remove clamps
that hold in wireway. Withdraw
wireway from pole – do not
remove entrance end fitting.
Step 2 Determine length “A” to be
removed from pole. Fold wires
back and cut length “A” from
shown ends of cover, base,
and wireway.
Step 3 To re-assemble – Replace
wireway into the base with
conductors inside. Replace
and tighten down clamps.
Snap cover onto pole.
Cover
Wireway
Base
Clamp
Length
“A”
Clamp
Entrance
End Fitting
TO SHORTEN ALTP POWER POLE
BEFORE INSTALLATION:
Length
“A”
Length
“A”
NOTE: Tele-Power Pole must extend above hanger
clamp with Pole stanchion resting on floor.