Legrand RC7AP User Manual

Rc7 p ok oke-thru abandonment plate, Cat. no. rc7ap installation instructions

RC7 P

oke-Thru Abandonment Plate

Cat. No. RC7AP

INSTALLATION INSTRUCTIONS

Walker

electrical systems conform to and should be

properly grounded in compliance with requirements of
the current National Electrical Code or codes adminis-
tered by local authorities.

All electrical products may present a possible shock or
fire hazard if improperly installed or used. Walker elec-
trical products may bear the mark as UL Listed and/or
Classified and should be installed in conformance with
current local and/or the National Electrical Code.

Products Covered: RC7APBK and RC7APVY

Punch Out Center Hole

Remove Cover

Attach Plate Using Screw Provided

Step 2

Step 1

Step 3

Option 1 – With Receptacle In Place:

Walker Systems, Inc.
1000 Innovation Drive, Williamstown, WV 26187

1 000 670 0700

Remove Cover, Receptacle and Receptacle
Wires or Conduit Adapter Assembly

Punch Out Both End Holes

Place Intumescent Wafers

Step 1

Step 2

Step 3

Attach Plate Using Screws Provided

Step 4

Option 2 – With Receptacle Out:

This manual is related to the following products:

WKD ProSeries Underfloor Duct Opening Reducer 880CM1-1 880CM2-1 880CM3-1 880CS1-1 880CS1-NA 880CS2-1 880CS2-NA 880CS3-1 880CS3-NA 880M1 880M2 880M3 880S1 880S2 880S3 828MAAP PCIQ PDU-TS1 Temperature Sensor WKD ProSeries Underfloor Duct Nonmetallic Fittings 525 Series Service Fittings