Legrand RC3 Replacement Scrub Water Cover Assembly Kit User Manual

Page 3

Step 9. Attach internal gasket and slide

Step 10. Stick wiring label on the inside of the

holder assembly.

junction box cover. Reattach receptacle
wires and junction box cover. Connect
Poke-Thru conductors according to required
device configuration (see schematic below).

CAUTION: Receptacle mounting means not

grounded. Grounding wire
connection required. For
isolated ground wiring,
connect ground leads
to a separate isolated
grounding conductor.
See NEC250-146(d).

CAUTION: Gasket must be set in place to provide

scrub water seal.

CAUTION: Do not over tighten cover mounting screws.

Step 11. If circuit is connected to an isolated

Step 8. Completed installation.

ground, apply IG icon on receptacle
slide as shown.

NOTE: The orange triangle shall only be placed on devices

that are wired for isolated ground. See NEC 250-146(d).

WHITE or NEUTRAL
from branch circuit

WHITE

from poke-thru receptacle

BLACK or HOT
from branch circuit

BLACK
from poke-thru receptacle

GREEN (jumper wire)
from poke- thru junction box

GREEN

from poke-thru receptacle

CONVENTIONAL WIRING SCHEMATIC

WHITE or NEUTRAL
from branch circuit

WHITE
from poke-thru receptacle

BLACK or HOT

from branch circuit

BLACK
from poke-thru receptacle

GREEN (jumper wire)
from poke-thru junction box

ISOLATED GROUND
from branch circuit

GREEN
from poke-thru receptacle

ISOLATED GROUND WIRING SCHEMATIC

GREEN or GROUND
from branch circuit
SYSTEM GROUND

WARNING:

Ground wire from junction box must be connected to SYSTEM GROUND.

Wiring Label