Legrand RC7AFFTC - Manual (Page 2)

Step 5. (If Applicable) Step 6. (If Applicable)
If stem is already installed, remove If retro-fitting an existing stem (RC7S) or
disposable plate. Place intumescent assembly (RC7AFF), remove cover assembly.
inserts into receptacle barrier. Install Replace old receptacle shell, intumescent
carpet/tile trim flange onto stem with inserts and screws with the ones that are
four #6-32 screws provided. provided. Attach new cover assembly with
four #6-32 screws provided.
RC7AFFTC Poke-Thru Less Junction Box
Cat. No. RC7AFFTC-LJB
(Applies to installations in the City of Chicago or Step 8. With assembly installed
other locations where local codes require the use remove screw plugs and
of a communication adapter, EMT compression install conduit adapters
fittings, and a junction box suitable for use in as necessary.
environmental air spaces.)
Step 7. Follow steps one thru four for installation.
Step 9. Completed assembly.
Replace
Replace
Old Receptacle Shell
New Receptacle Shell
Receptacle Shell – Use
Only if Old Receptacle
Shell is Currently in
the Unit. Otherwise,
Discard New Shell.
Replace
Once Poke-Thru is Pushed into
the Cored Hole, from Below,
Install a EMT Compression Fitting
(Not Supplied) and Junction Box
(Not Supplied) to the Conduit
System. Complete Installation
Per NEC and Local Codes.
Attach COM75 Adapter
(Included with LJB Units) Per
Instructions Supplied with Unit