Legrand 861 Series Outlet Boxes for Wood - Manual (Page 2)

2
2. Attach trim flange to outlet box
using (4) #6 x 3/8" flat head screws.
3. Align gasket over receptacle and press
bead into flange.
4. Attach the slide cover with (2) #6 cover
screws. Do not over tighten screws. Apply
icon on receptacle slide if wired for isolated
ground circuit. Push box into the hole until
firmly seated against floor finish.
1. Wire and attach the quad receptacle
to the outlet box using (2) #8 x 3/4"
round head screws.
CAUTION: Receptacle mounting means not grounded. Grounding
wire connection required. For isolated ground wiring,
connect ground leads to a separate isolated ground
conductor. See NEC 250-146(d).
CAUTION: Gasket must be set in place to
provide scrub water seal.
CAUTION: Do not operate tile stripper or resurfacing equipment over top of
cover. This may result in damage to the finish of the product.
NOTE: Place Orange triangle on devices that are wired for isolated
ground. See NEC 250-146(D).
Gasket
Slide Cover
CONVENTIONAL WIRING SCHEMATIC ISOLATED GROUND WIRING SCHEMATIC
BLACK or HOT BLACK BLACK or HOT BLACK
From branch circuit from poke-thru receptacle From branch circuit from poke-thru receptacle
WHITE or NEUTRAL WHITE WHITE or NEUTRAL WHITE
From branch circuit from poke-thru receptacle From branch circuit from poke-thru receptacle
GREEN or GROUND GREEN ISOLATED GROUND GREEN
From branch circuit from poke-thru receptacle From branch circuit from poke-thru receptacle
System Ground
GREEN or GROUND GREEN (jumper wire)
From branch circuit from poke-thru
System Ground junction box
GREEN (jumper wire)
from poke-thru junction box
WARNING: Ground wire from junction box must be connected to system ground.
QUAD RECEPTACLE COVER INSTALLATION: Cat No. 861QTC
2. Remove screw plugs and install flexible
conduit fittings with conduit.
1. Attach conduit flange to the outlet box
using (4) #6 x 1/2" pan head screws.
Push the box into the hole until firmly
seated against the floor finish.
NOTE: Keep screw plugs for future abandonment.
CAUTION: Do not operate tile stripper or
resurfacing equipment over
top of cover. This may result
in damage to the finish of
the product.
FURNITURE FEED COVER INSTALLATION: Cat No. 861FFTC