Legrand 880CM1-1 - Manual

Adjustable Partition Kit for
Omnibox
™ Floor Box Covers
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 005 001 – June 2006
Wiremold / Legrand electrical systems conform to and should
be properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold / Legrand electrical
products may bear the mark as UL Listed and/or Classified and
should be installed in conformance with current local and/or the
National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
Products Covered:
Adjustable Partition Kit: 880SAP, 880MAP, 880CSAP and 880CMAP
Step 1 (Optional)
Step 3
Step 2
Small adjustments
to avoid binding
Step 4
Tighten Nuts with
7/16" Wrench
Raise upper Partition
Flange
(Sold separately)
Adjusting Screw
(Sold separately
Beveled end in slot
Omnibox
(Sold separately)
Remove Knockout
Install Bushing for
wire pass-through
Cast Iron Box
position
Cast Iron Box
position
Bolts must be loose
(free moving)
Steel Box position