Legrand 825 Series Floor Box - Manual (Page 2)

Products Covered: 825SFCK
Activation:
1. Remove mudcap and any debris.
2. Route cables through box assembly.
3. Place steel adapter in adjusting ring and thread
825C Brass Ring into adjusting ring until tight.
4. Place 500 Series fitting base (not included
over 825C Brass Ring.
5. Thread locking nipple into adapter until tight.
6. Tighten #8-32 screws to 500 Series Base
(see Figure 3).
Products Covered: 825CK-1, 825CK-3/4, 835CK-1/2
Activation:
1. Remove mudcap and any debris.
2. Place support disc in floor box adjusting ring.
3. Place gasket on support disc in adjusting ring
(see Figure 4).
4. Thread brass floor plate into adjusting ring until
flush with floor using box wrench provided with
box (see Figure 5).
5. Thread brass plug into brass
floor plate until flush with floor
using box wrench provided
with box (see Figure 6).
Figure 3
Figure 4
Figure 5
Figure 6
#8-32 Screw
Locking Nipple
500 Series Base
825C Floor Ring
Steel Adapter
Box Wrench
825C Floor Ring
825A Plug
Box Wrench
8256A Plug
825C Floor Ring
Gasket
Support Disc
825CK
Wiremold / Legrand
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
1 001 438 R1 0906 © Copyright 2006 Wiremold / Legrand All Rights Reserved