Legrand FIT AL241S-HB - Manual

AL241S-HB
Bench/Table Top Service Fitting
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 1 003 194 – February 2003
Step 1
Determine configuration of receptacles in box and install short
or long barrier as required (receptacles must be installed in the
compartment containing the ground screw).
Step 3
Attach receptacles to base and attach faceplates using
#6-32x1/2" screws provided in hardware bag. Step 4
Attach cover to box using #8-32x5/16" screws provided
in hardware bag.
Step 2
Remove appropriate knockouts in power and communications
compartments, then cut holes to correspond with these in the
furniture surface on which the box will be mounted (holes must
be large enough to accommodate conduit fitting being used).
Pull 1/2" [12.7mm] or 3/4" [19.1mm] trade size flexible
conduit through furniture surface
and attach to base with
conduit fitting. Attach base
to furniture surface using
appropriate fasteners. Wire
receptacles according to
NEC and local codes.
NOTE: Use long partition when receptacles are to be
mounted adjacent to each other. Use short partition
when receptacles are to be mounted back-to-back.
Walker ® electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Walker electrical products
may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
The Wiremold Company
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
850 Gartshore Street • Fergus, Ontario N1M 2W8
1-800-741-7957 • FAX 519-843-5980
1 003 194 0203 © Copyright 2003 The Wiremold Company All Rights Reserved