Legrand 6ATC - Manual

Evolution ™ Series
Poke-Thru Device Pre-Pour Sleeve
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 008 320 R1 – Updated June 2009
Wiremold / Legrand electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold / Legrand electrical
products may bear the mark as UL Listed and/or Classified and
should be installed in conformance with current local and/or the
National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
Products Covered: 6PPS, 8PPS, 6PPS-PD, 8PPS-PD
NOTE: Cat. No. 6PPS, 8PPS, 6PPS-PD and 8PPS-PD are not UL Listed or Classified Products.
The Sleeve MUST be removed before installing a 6AT or 8AT Series Poke-Thru Device.
STEP 1. Cut hole in deck to allow Pre-Pour Sleeve to pass
through. Refer to chart for proper hole size. Attach
Mounting Brackets to Pre-Pour Sleeve. Replace Cap.
STEP 2. Attach Pre-Pour Sleeve assembly to the Deck
with Tube protruding through Hole using sheet
metal screws (not provided).
CATALOG HOLE
NUMBER DIAMETER
6PPS 6 1/16" [154mm]
8PPS 8 1/16" [205mm]
CAUTION: Tube must be installed plumb and remain
plumb during the concrete pour.
NOTE: Insure that all gaps between deck
and tube are sealed completely.
CORRUGATED STEEL DECK INSTALLATION:
STEP 1. Attach Mounting Brackets to Pre-Pour Sleeve.
STEP 2. Attach Pre-Pour Sleeve assembly to the Deck.
PLYWOOD DECK INSTALLATION:
NOTE: Pre-Pour Sleeve protrudes 6" [152mm]
above crest of the deck.