Legrand M6BZNET-15 - Manual

SNAP-ON/SLIDE-OFF:
Screw mounting clips
into mounting surface
on a straight line.
Measure 1" [25mm] in
from each end of the
unit. Place unit’s mounting rails in
one side of mounting clips and
snap in position so unit is flush with mounting
surface. To remove unit, simply slide it out
of clips.
Perma Power Computer Grade Surge Protectors from Wiremold / Legrand
are available in impact resistant housings and in lengths up to 13 1/4"
[337mm]. All Perma Power Computer Grade Surge Protectors are Listed or
Recognized by Underwriters Laboratories under File No. E66421 and all 15A
Units are CSA Certified under File No. LR62645. All units are in compliance
with the National Electrical Code and the Canadian Electrical Code.
TYPICAL INSTALLATION:
All Perma Power Computer Grade Surge Protectors from Wiremold / Legrand conform to and should be installed and properly grounded in compliance with requirements of the
current National Electrical Code, Canadian Electrical Code or codes administered by local authorities. CAUTION: All electrical products may represent a possible shock or fire
hazard if improperly installed or used. Do not plug into another relocatable power tap. The 3-prong, grounding type plugs in all units are for use with 3-prong, grounded
receptacles only. Modifying or bypassing the ground pin for use in a non-grounded receptacle or plugging into another relocatable power tap may lead to electrical shock, is not
recommended and voids the product warranty. All units are designed for interior use in dry locations only. Check all local and national electrical codes for proper installation.
Computer Grade Surge Protectors
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: INSPPR01R3 – Updated March 2007
j
MOUNTING INSTRUCTIONS:
KEYHOLE MOUNTING:
Measure distance from
center of keyhole slots.
Mark this distance on the
surface to be mounted.
Install mounting screws into surface. Leave
screw head about 1/8" [3mm] above surface.
Place unit over screws. Slide unit left, right or
down to secure it in position. PHONE/FAX/DATA LINES:
Install surge protector
according to instructions
above. Insert one end of the
6' [1.8m] phone/fax/data cord
(provided) into wall jack.
Insert other end into the “LINE
INPUT” jack on the surge
protector. Insert one end of the phone/fax/data cord,
from the equipment to be protected, into the “LINE
OUTPUT” jack on the surge protector. Insert the other
end into the appropriate jack on the equipment.
.