IHSE USA 234 Series VTO2/VRO2 KVM-Extender - Manual (Page 6)

VTO2/VRO2 V.6.00 –5 STRAND KVM-EXTENDER
6
1. Quick Setup
This section briefly describes how to install your KVM extender system and optimise the
video signals. Unless you are an experienced user, we recommend that you follow the full
procedures described in the rest of this manual.
Install System
1. Connect Remote unit to KVM.
2. Connect Local unit to CPU or switch.
3. Connect Local and Remote units with fibre interconnection cable.
4. Power up the system.
YES
NO
Does the 7-
segment display show
’0’?
NO
YES
Solve the problem as described in
the Troubleshooting section
(page 35).
Wait until the dot lapses
NO
YES
The fibres for data transmission
(1 + 2) are swapped – switch the
fibres at one device (see page 18).
Does the 7-
segment display show
’C’?
Is the dot on the
7 segment display
illuminated?
Done