IHSE USA 234 Series VTO2/VRO2 KVM-Extender - Manual (Page 30)

VTO2/VRO2 V.6.00 –5 STRAND KVM-EXTENDER
30
5. Monitor Setup
This schematic diagram shows the principles of data transmission through the extender
system:
Normally you should not need to make any modifications. However, under some
circumstances, you may want to customize the extenders:
Changing the Graphics
The factory setting for our devices is to transmit VGA signals to a VGA screen (VGA
in/VGA out). By changing the appropriate jumper settings the units can also be used for:
• VGA in/RGB out: RGB monitor displaying output from a VGA graphics card
• RGB in/RGB out: RGB monitor displaying output from an RGB graphics card
• RGB in/VGA out: VGA monitor displaying output from an RGB graphics card