IHSE USA 234 Series VTO2/VRO2 KVM-Extender - Manual (Page 15)

INSTALLATION
15
3.3 System Setup
To install your VTO2/VRO2 V6.00 KVM-Extender system:
1. Switch off all devices.
2. Connect your keyboard, monitor, mouse, audio device and serial device to the Remote
unit (depending on type of device). Ensure that you attach the keyboard and mouse
connectors to the correct ports. The keyboard connector is purple; the mouse connector
is green.
3. Connect the CPU to the Local Unit, using the supplied CPU cable. Ensure that you
attach the keyboard and mouse connectors to the correct ports. The keyboard connector
is purple; the mouse connector is green.
4. Connect the 6V power supplies to the Local and Remote units.
Only use the power supply originally supplied with this
equipment or a manufacturer-approved replacement.
5. For a dual access system, connect the keyboard, mouse and monitor for the Local
console to the appropriate ports on the Local unit. The ports may also be used to feed
into a KVM switch.
6. Connect the Interconnection cable (Multimode Fibre Cable) from the Remote unit to the
Local unit. Ensure that you attach the fibre connectors to the correct ports. R goes to R,
G to G, B to B, 1 to 1 and 2 to 2.
7. Power up the system.