IHSE USA 234 Series VTO2/VRO2 KVM-Extender - Manual (Page 12)

VTO2/VRO2 V.6.00 –5 STRAND KVM-EXTENDER
12
2.6 How to Use This Guide
This guide describes the installation and configuration of the VTO2/VRO2 V6.00 KVM-
Extender Series. Although the connection and operation of the system is relatively
straightforward, you should consider the following before getting started:
Connection & Compatibility
If you have purchased a VTO2/VRO2 V6.00 KVM-Extender Kit, this will contain all the
cables required to connect the Local unit to your PC or KVM switch. The Remote console
(keyboard, monitor and mouse) and any audio and serial equipment connect directly to the
Remote unit.
For information about connection and installation, see Installation, page 13.
Graphic Source (RGB or VGA)
The device can transmit RGB signals as well as VGA. In addition, it is able to convert from
VGA to RGB as well as from RGB to VGA.
Factory setting:
VGA (see page 27).
Fibre Cable (50µ or 62,5µ)
The VTO2/VRO2 V6.00 KVM-Extender can be used with 50µ or 62,5µ fibre cable. The
transmission power must be adjusted to the type of cable. You need not to modify the setting,
if at least one of the following two circumstances become true: 1
st
the cable type is 50µ, 2
nd
the cable length exceeds 100m. (see also page 27)
Automatic Gain Control (AGC)
In some applications (e.g. RGB Signals) it may be necessary to switch off the Automatic Gain
Control.
Factory setting:
Automatic Gain Control ON (see page 27)
Compatibility
The devices in version 6.00 are NOT compatible with previous versions.