Hoefer SE300 miniVE - Manual (Page 14)

•
p6
Place and seal the sandwich on the module

Take care to “square” the three sealing sides of the
sandwich. Hold the sandwich like a deck of cards and
gently tap the bottom against a flat surface.

Notched plate side down, lay the sandwich on the
module (Fig 5). Fit the gel sandwich within the guides
at both sides (a) and against the guide feet at the
bottom (b).

While gently holding the sandwich against the
module, swing one clamp into position over the
spacer, taking care not to bump the sandwich out of
alignment (Fig 6).
Important! Proper alignment is
essential to prevent leakage.
Note: Once the sandwich is care-
fully aligned, hold the flat sides
firmly between your thumb and
fingers, near the notch.
Fig 5. Placing the sandwich in
the module.
a
a
b
b
notch at top
Fig 6. Positioning the clamps.