Harken 7413.15 MKIV Hydraulic Jib Reefing & Furling - Manual (Page 21)

MKIV Hydraulic Unit 3 21
ROD RIGGING
Insert two cotter pins and
spread. Clean excess Loctite ®
from terminal body using
special care to ensure that
there is no red Loctite ® on
threaded stud.
Assembly Rod Rigging: Rod Adapter Stud
Apply a few drops of red
Loctite ® to threads of nosepiece.
Screw main threaded stud
portion onto bronze nosepiece
until flats align with two cotter
pin holes in terminal body.
Tip: Turn nosepiece completely
into threaded stud portion.
Flats will be close and may
only require a small half turn
to align with cotter pin holes.