Harken 7413.15 MKIV Hydraulic Jib Reefing & Furling - Manual (Page 16)

16 MKIV Hydraulic Unit 3
Assembly Top Foil/Connectors
Slip connector on wire, mating hook
of plastic bushing with connector.
Tip: In cooler weather, keep sealed
adhesive in pocket to keep warm. Use
instructions below to fill injector less
than half way; you will only use a small
amount of adhesive. Refill if needed
but do not keep open sealant for long
periods. Use adhesive within 3 hours.
Use cap of adhesive to break seal. Remove
injector tip cap and plunger. Hold injector
at an angle with applicator tip facing down.
Squeeze adhesive into tube so lower half
of injector is full as shown. Keep tip free
of sealant to let air inside.
Loading Injector with Adhesive
Adhesive in
lower half