Harken C8436 MKIV Jib Reefing & Furling - Manual (Page 9)

Slip 9.75" (248mm) connector on wire,
mating hook of plastic bushing with
connector.
Tip: In cooler weather, keep sealed
adhesive in pocket to keep warm. Use
instructions below to fill injector less
than half way; you will only use a small
amount of adhesive. Refill if needed
but do not keep open sealant for long
periods, use adhesive within 3 hours.
Use cap of adhesive to break seal. Remove
injector tip cap and plunger. Hold injector
at an angle with applicator tip facing down.
Squeeze adhesive into tube so the lower
half of the injector is full as shown. Keep
tip free of sealant to let air inside.
Loading Injector with Adhesive
Adhesive in
lower half
Assembly Top Foil/Connectors
4/18/07 Nautor MKIV Furling 9