Harken C8436 MKIV Jib Reefing & Furling - Manual (Page 16)

Check the clearance between the top of the
foil and top terminal.
TIP: Check clearance when the unit is on
the ground, before raising the headstay
into position.
Slide halyard swivel above feeder. Place
feeder in foil recess. Push screw down
so tab catches under foil. Tighten screw.
Note: Screw will turn with some difficulty.
It has plastic coating so it does not vibrate
loose.
Important—When removing screw,
loosen no more than one full turn.
Slide screw up and remove feeder.
Tip: Do not remove foil clamp screws
to adjust foil. Loosen screws, hold foils
and bring clamp away from foils. Adjust
and reclamp.
Assembly Attach Feeder/Final Foil Assembly
Assembly Check Top Foil Clearance
16 Nautor MKIV Furling 4/18/07