Guralp Systems CMG-DM24S12AMS - Manual (Page 9)

CMG-DM24S12AMS Operator's guide
2 Quick start
1. If you are using a GPS timing signal to synchronize your
instruments, first connect a GPS receiver to the digitiser's GPS
socket.
2. Power up the system. The DM24S12AMS module can take power
from the mains, or from any ~12 V DC supply such as a battery or
UPS. If a rechargeable battery is connected to the BATTERY/UPS
socket, and enough external power is provided, the battery will
be recharged as required.
3. Open the lid of the unit, and power up the built-in laptop PC,
which is configured to automatically run the latest version of
Güralp's Scream! software. After a short while, Scream!'s main
window will open:
4. Scream! will then connect to the digitiser. The DM24S12AMS
houses two separate 6-channel digitiser modules, which work on
CH 1-6 and CH 7-12 respectively. After a short wait, the two
modules should appear under Local in the left hand pane, each
on its own Com port.
March 2004 9