Guralp Systems CMG-DM24S12AMS - Manual (Page 14)

CMG-DM24S12AMS Operator's guide
•
The length of pre-trigger and post-trigger periods (see also
“Triggering” in Section 3.1 )
•
Calibration signal options
•
Mass control functions
Some of these options can also be altered in the Configuration setup
window. For more information on the Control window, see
Section 3.2,
“Controlling digitisers” .
If you need a more powerful interface to the digitiser modules, you can
also issue commands to it directly using Scream!'s terminal mode. A
terminal window is opened by right-clicking on the digitiser's entry in
the list and selecting Terminal.... The digitiser will stop collecting data
while you have a terminal window open. For more details on the
DM24's terminal mode commands, please see its technical
documentation (available from Güralp Systems.)
The remaining sections of this chapter describe in detail the
configuration options available for the DM24S12AMS's in-built
digitisers. Many of these options will also be available for other Güralp
digitisers or digital sensors connected to the unit's DIGITAL A – F ports.
For the most accurate information, you should consult the Operator's
Guide for the digitiser or sensor you connect.
14 Issue B