Guntermann & Drunck CATCenter X systems Communicaton modules - Manual (Page 24)

Guntermann & Drunck GmbH CATCenter Communication Components
Page 24
Open the following submenu by pressing the F5 key or the ENTER key:
E d i t C o n s o l e
C o n s o l e n a m e C O N 0 0 0 0 1 2 4 5
Edit Config rights…
Edit Operation rights…
Edit target access rights…
New target rights
full
Auto Logout 00 off
Screensaver time 00 off
Scancode set 2
OSD keyboard layout German
OSD by mouse no
Remember last user name yes
Numlock emulation no
Keyboard required no
Display Tradeswitching no
OSD blocked no
Reset console video data
Video
ESC TAB: Edit Name F2: Save
The Display Tradeswitching line allows you to set the display for the
tradeswitch function to one of the following values:
- Temporary => Yes (disappears approx. 5 seconds after
switching)
- Off => No (display is not shown)
This setting can be established for the TS slave consoles. On the TS master
console, the display is permanently visible.
After you move the cursor to the Display Tradeswitching field, you can use
the
SPACEBAR (toggle) to select the desired option (Yes/No).
Note:
You have to establish these settings for every console you wish to integrate
into a tradeswitching workstation.
Default setting: Yes
3.5 Configuring a Workstation
Create and configure a workstation after carrying out the steps in Chapter 3.3
and 3.4 .