Grandstream GXV3140 User Manual - Manual (Page 41)

FIRMWARE VERSION 1.0.7.80 GXV3140 USER MANUAL Page 41 of 151
10%.
Advanced Settings/Ring Tone
Call Progress Tones Using these settings, users can configure ring or tone frequencies based on
parameters from the local telecom provider. By default, they are set to the
North American standard.
Frequencies should be configured with known values to avoid
uncomfortable high pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise it
will ring ON ms and a pause of OFF ms and then repeat the pattern. Up to
three cadences are supported.
Default Ring Cadence This defines the ring cadence for the phone. The default setting is:
c=2000/4000;
MAINTENANCE PAGE DEFINITIONS
Maintenance/Network Settings
Address Type This selects the type of IP address assigned: DHCP, PPPoE or Static IP.
PPPoE When PPPoE is selected, the user needs to enter the following: PPPoE
Account ID, PPPoE Password, PPPoE Service Name.
Static IP When Static IP is selected, the user needs to enter the following: IP
address, Subnet Mask, Default Gateway, Preferred DNS Server and
Alternate DNS Server.
DHCP Host name (Option
12)
Default is blank. This option specifies the name of the client. This field is optional
but may be required by some Internet Service Providers.
DHCP Domain name
(Option 15)
Default is blank. This option specifies the domain name that client should use when
resolving hostnames via the Domain Name System.
DHCP vendor class ID
(Option 60)
Default is GXV. Used by clients and servers to exchange vendor-specific
information.
Alternate DNS Server This field sets the preferred DNS server for the user.