Grandstream GXV3140 User Manual - Manual (Page 146)

FIRMWARE VERSION 1.0.7.80 GXV3140 USER MANUAL Page 146 of 151
SOFTWARE UPGRADE
The GXV3140 can be upgraded via TFTP/HTTP/HTTPS by configuring the URL/IP Address for the
TFTP/HTTP/HTTPS server and selecting a download method.
Configure a valid URL for TFTP or HTTP; the server name can be the FQDN or IP address format.
Examples of valid URLs：
1. firmware.grandstream.com
2. fw.ipvideotalk.com/gs
There are two ways to setup a software upgrade server: The Keypad Menu or the Web Configuration
Interface.
UPGRADE VIA KEYPAD MENU
To configure the software upgrade server through the keypad menu; select
“Menu”->”Settings”->”Maintenance”. In the “Upgrade” subpage, users may then select the upgrade mode
and enter the IP address or FQDN of the Firmware server and the System Config server. After making the
changes, use the F3 softkey to save the new settings.
UPGRADE VIA WEB BROWSER CONFIGURATION PAGE
Open a web browser and enter the IP address for the GXV3140. Next, log in with the administrator
username and password. Under Maintenance, select “Upgrade and provisioning”, enter the IP address
or the FQDN (URL) of the upgrade server and choose to upgrade via TFTP or HTTP/HTTPS. Save the
changes and reboot the unit.
At this moment, the LCD will display the progress of the software download/upgrade. Please do not disrupt
or power down the unit.
Note: The software upgrade will last up to 5 minutes (through the LAN side) and may take longer when
upgrading through the Internet (limited by the network bandwidth). Grandstream recommends
downloading and upgrading the software in a controlled LAN environment.
NO LOCAL TFTP SERVERS
For users without a local TFTP server, Grandstream offers a NAT-friendly TFTP server. This enables users
to download the latest software upgrades for their phone via this server. Please refer to the webpage:
http://www.grandstream.com/support/firmware .