Gasboy Current Loop Driver Ferrite - Manual

MDE-4707 Current Loop Driver Ferrite Installation Instructions · September 2007 Page 1
Introduction
Purpose
This document is shipped when you order one of the following:
• Current Loop Driver Unit - CFN (C05688)
• Cable (CRIND) & Adaptor (C06326)
Overview
To comply with FCC requirements, the Current Loop Driver Unit requires one Transient
Suppressor or Ferrite (Q11433-112) on each of the RS-422 cables connected to the unit. There
could be one or two RS-422 cables (CRIND Port, SC Port), depending on the site
configuration (see
Figure 1 ).
Table of Contents
Topic Page
Introduction 1
Important Safety Information 2
Installation of the Ferrite 4
Warranty
For information on warranty, refer to MDE-4255 Gasboy’s Warranty Policy Statement. If you
have any warranty-related questions, contact Gasboy’s Warranty Department at its Greensboro
location.
MDE-4707
Current Loop Driver Ferrite
Installation Instructions
September 2007