beautypg.com

Gasboy Islander II Floppy Drive User Manual

Gasboy Hardware

background image

C36013

Rev. 1108

ISLANDER II FLOPPY DRIVE INSTALLATION FOR SOFTWARE UPGRADES

1. Turn the AC power off.

2. Connect the ribbon cable to P13 of the Islander

CPU board.

3. Connect the DC power cable to any one of the

three DC outputs of the power supply. For
Islanders with receipt printers, you will need to
remove the printer cable and plug the floppy drive
cable in its place.

4. Turn the AC power on.

5. Poll the site and if interfaced to a bank network,

perform a settlement (see the section in your
network manual pertaining to settlements). If the
bank router software has a menu, choose the
write to file option.

6. Perform

a

SYSBACK and TRANBACK. Copy the

SYSBACK.DTA and TRANBACK.DTA files to a
formatted floppy diskette labeled Backup.

7. Copy the existing FRAMOS.CFG and any user-

created command files to the Backup floppy
diskette.

8. Put the new Release disk in floppy drive and type

RCP A: E: All the files on the Release disk are
written to the PCMCIA card in drive E:. When the
copying is complete remove the Release disk.

9. Put the new Applications disk in floppy drive and

type RCP A: E:. All the files on the Applications disk are written to the PCMCIA card in drive E:. When the
copying is complete remove the Applications disk.

10. If the Site is using a Bank Network, put the Network disk in floppy drive and type A:CPROUT. Select the

Network that the site is using and the proper network support files will copy to the PCMCIA card in drive E:.
When the copying is complete remove the Network disk.

11. Type REBOOT;A so that the Islander is running the new software. After the site reboots, sign back on.

12. Put the backup floppy diskette in drive A: and type RCP A: E:. All the files on the Backup disk are written to the

PCMCIA card in drive E: When the copying is complete remove the Backup disk.

13. Type FIX CONF and press ENTER.

NOTE: You must run TABLE to verify that memory space has not been over allocated before you proceed with
Step 14. Always make sure that the space remaining is a positive number and not a negative number. If more
free space is needed, try reducing the transaction table size.

14. Type REBOOT;A. After the Islander reboots, sign on and type RESTORE EV. This will restore the data saved

in SYSBACK.DTA. Type RESTORE EV FR TRANBACK.DTA. This will restore the data saved in
TRANBACK.DTA. Type RUN;I. This will restart the site.

15. Turn the AC power off.

16. Remove the ribbon and DC power cables. If the receipt printer cable was removed in Step 3, replace it.

17. Turn the AC power on. Verify the Islander display is scrolling through messages and can turn on the pumps.

Upgrade procedure is complete.