Gasboy SCII - Manual (Page 3)

C35803 Rev 2037 Page 3
INSTALL THE UPGRADE: V1.0 TO V2.0X OR ABOVE ON A SCII WITH TWO FLOPPY DRIVES.
If upgrading from V1.0 to V2.3 or above, special considerations apply. Please contact your service representative before
you proceed.
1. Verify that the RESTORE.BIN file in the BIN directory of the V2.0x or above disks is dated 3-29-95 or later.
2. Do a P SIG and note the users, permission levels.
3. Choose a time when the site is normally closed or slow to install the upgrade.
4. Perform your end of day procedure.
5. Stop the site.
6. Type P DA, press ENTER and note the trans #.
7. Insert the V1.0 Release disk in the A: drive and the new Release disk in the B: drive. Type CP SYSBACK.DTA B:
and press ENTER.
8. Insert the new Applications disk in the A: drive and the V1.0 Release disk in the B: drive, and type:
A:BIN/CONVERT2 B:FRAMOS.CFG A:FRAMOS.CFG and press ENTER.
9. The prompt Insert SCII V1.0 Release disk with current configuration then RETURN: will appear. This disk was
inserted in the previous step, just press ENTER.
10. When prompted, Do you want to save this configuration (Y/N):, insert the new Release disk in the A: drive,
remove the disk from the B: drive, type Y and press ENTER.
11. Power-down the Site Controller and remove the cover. Locate J1 on the Memory Add Module and remove the
jumper. Set the cover back on but do not secure it yet.
12. With the new Release disk still in A: drive, hold the CPU reset button while powering-up the SCII and hold it for 10
seconds. Sign on after the files are reconstructed.
13. Insert the new Applications disk in the B: drive.
14. Type FIX TR;I and press ENTER.
15. Type RESTORE EV and press ENTER.
16. Type RESTORE TRANS FR TRANBACK.DTA and press ENTER.
17. Type LO TR xxxx and press ENTER.( xxxx = trans # noted in step 6 above.)
18. Type AD SIG and load the users, permission levels and sign on codes recorded in step 2 above.
19. Type RUN;I and press ENTER.
20. Type SYSBACK and press ENTER.
21. Use the CP command to copy any user-created files from the V1.0 Release disk to the new Release or Applications
disk.
22. Once the site is up and running, secure the cover to the Site Controller.
23. Update the spare Release disk made in step 5 of the Perform Backups section of this document or use
SWAPCOPY+ to copy the entire Release disk again.