beautypg.com

Gasboy Hard Drive User Manual

Gasboy Hardware

background image

C35348 Rev. 07/02/03

Page 1

INSTALLATION INSTRUCTIONS: HARD DRIVE OPTION KIT C05986

This kit should contain the following:

Item

P/N

Description

1

C34412

Bracket, HD Support

2

C09162

Hard Disk Drive, SCSI

3

C04035

Screw, #6-32 x 1/4” (Qty 4)

4

068843

Washer, #6 Locking (Qty 4)

5

C01152

Screw, #4-40 x 1/4” (Qty 2)

Item

P/N

Description

6

C01159

Washer, #4 Locking (Qty 2)

7

C03473

Nut, #4-40 Hex Keps (Qty 2)

8

C05984

Cable Assy., HD Ribbon

9

C05552

Cable Assy., HD Power

10

C34410

Cover Bracket

System Requirements: C05852 CPU PCB containing a Dsite chip (U36) of version 4.0F. The hard drive is not
compatible with the C05328 CPU PCB. If your system does not meet this requirement, consult your sales
representative.

Important: Before you begin, make sure you have copies of your Release and Applications disks and a
backup of your site data. Change your command search path in SYS_PAR, page 9 to default (spacebar)
and save this change.

1.

Turn off power to the unit and remove the cover.

2.

Remove spot-welded cover plate, if present, from Drive B position on base.

3.

Remove the original disk drive support bracket from the cover.

4.

If the disk drive support mounting bracket already has
mounting holes for a hard drive, skip to the next step. If
not, relocate the original 3-1/2” drive to the new support
bracket (item 1).

5.

Verify that the drive is jumpered as shown below:

Fujitsu:

6.

Mount the new hard drive to the drive support bracket using
four screws and washers (items 3 & 4). Mount cover
bracket (item 10) to drive support bracket using two screws,
washers, and nuts (items 5, 6 and 7).

7.

Mount the drive support bracket onto the cover.

8.

Adjust the position of the drive and drive support bracket so
the cover slides easily onto the base.

9.

Plug the 68-pin to 50-pin adapter into the hard drive. Then
plug the 50-position ribbon cable (item 8) into P14 of the
CPU PCB and plug the opposite end into the adapter.

10. Plug the power cable into the power supply, and then into

the hard drive.

11. On the CPU Board, close DIP switch 1, position 2 to enable

the hard drive.

12. Reinstall the cover, without mounting screws, and turn on the power. You should hear the hard drive begin to

spin.

13. Reinstall the cover mounting screws.