Gasboy 9120Q - Manual (Page 5)

MDE-4629 High Hose Retriever Kit Installation Instructions for Models 9120Q/K and 9820Q/K · January 2007 Page 5
Installation of the High Hose Retriever Kit for Models 9120Q/K and 9820Q/K
Installation of the High Hose Retriever Kit for Models
9120Q/K and 9820Q/K
To install the High Hose Retriever Kit for models 9120Q/K and 9820Q/K, proceed as follows:
Mounting the Hose Retriever
1 Assemble the reel and clamp assembly (item 1) on to the support post (item 2) with the screw
(item 4), lock washer (item 8) and washer (item 7).
2 Install the caplug (item 3) on top of the support post (item 2).
3 Install the reel and support post assembly on the side panel with screw (item 5), washer (item
7) and lock washer (item 8) and to the base with hex head bolt (item 6), washer (item 7) and
lock washer (item 8). Install the plug buttons (item 10) in these two locations.
Mounting the Hose to the Retriever/Clamp Assembly
1 Assemble the clamp to the hose. The clamp should be positioned such that the hose does not
touch the ground when the nozzle is hung in the nozzle boot.
2 Pull out the hose and check the operation of the Retriever and the lay of the hose.
Figure 1: High Hose Retriever Overview
3
1 4, 8 and 7
9, 10, 5, 8 and 7
10, 6, 8 and 7
2
The installation of the High Hose Retriever is complete.