Gasboy 9820K Totalizer Kit - Manual (Page 6)

Installation of the 9820K Totalizer Kit
Page 6 MDE-4617 9820K Totalizer Kit Installation Instructions • December 2006
Figure 2: Back View
Totalizer Mounting Bracket (1)
9-digit Counterclockwise
Odometer (3), (4)
Screw MH PNH PHL 6-32X (7)
Metric Flange Nut (2)
Spirol Pin .062 X .500 (6)
4 Install the assembled Drive Cable Assembly with the Odometer/Totalizer to the Totalizer
Bracket mount using the two 6-32 screws. Then, use the two 8-32 Hex KEPS
® nuts to attach
this completed assembly to the Totalizer Bracket (see Figure 2 ).
5 Install the Totalizer Bracket to the frame with two M8 X 18 thread-forming screws (see Figure
1 on page 5 ).
6 Route the Drive Cable Assembly under the meter and up to the flange of the frame. Use the
Cotter Pin to install the loose end of the Drive Cable Assembly to the Gear Train Assembly
under the pulser housing (see
Figure 1 on page 5 ).