Gasboy 9800 Rear Totalizer Kit - Manual (Page 2)

Page 2 C35626 Rev. 8008
7. From rear of unit and on the underside of the platform, locate the 2-position connector (a) hanging free. Plug the mating
2-position connector (b) of the rear totalizer cable into connector (a).
8. Mount bracket/sensor end (c) of rear totalizer cable to rear flange of platform with two screws (d) similar to existing
totalizer sensor on front flange of platform.
9. Secure display panel(s) in the upright position.
10. Attach bezel(s), making sure each is seated properly to insure a watertight seal.
11. If new rear totalizer feature does not initially work, you may need to re-align the bracket/sensor attached in Step 8 to
obtain proper actuation through the dial face.
12. Attach and lock the front panel.