Gasboy 9820A User Manual
Gasboy Hardware
032630 Rev. 0096
Page 1
VAPOR RECOVERY KIT INSTALLATION INSTRUCTIONS
FOR MODEL 9820A
This instruction sheet covers the installation of the Model 9820A, Vapor Recovery Kit (Gasboy P/N 032629). You should
have received the following: (vapor recovery kit does not include high hose retriever, hose, nozzle, swivel, and breakaway)
Item
Qty.
P/N
Description
1
1
042776
Discharge Assembly
2
1
041645
Panel, Right Side (VR)
3
1
028929
Grommet
4
1
041648
Bracket, Vent Support
5
2
051821
Bolt 5/16-18 x ¾
6
2
068874
Washer, Lock 5/16
Item
Qty.
P/N
Description
7
1
049013
O-Ring
8
2
038605
Nut 5/16-18 Hex
9
4
068080
Washer 5/16
N/A
1
032630
Instruction Sheet
N/A
1
035282
Warning Sheet
Important: Read all instructions before beginning installation. Also, read and follow all precautions
regarding remote dispensers and pumps on the Warnings and Safeguards sheet, 035282, included in this
kit. Before performing any work which may produce sparks (e.g. drilling, use of power tools, etc.), remove
dispenser a safe distance from any flammable materials.
Installing Right Side Panel
1.
Remove front door panel (key required)
2.
Remove rear door panel (key required)
3.
Remove four (4) 1/4-20 nuts from top cover assembly and remove top cover.
4.
Remove discharge pipe elbow.
5.
Remove three (3) nuts from right side panel which secure panel to base. Remove right side panel and discard.
Installing Discharge Assembly
6.
Remove two (2) 5/16-18 bolts from discharge casting and two (2) 1/4-20 bolts from discharge clamp. Remove
discharge assembly from unit. NOTE: Replace O-ring with supplied (item 7) O-ring. Apply lithium based
grease to O-ring.
7. Install new vapor recovery discharge assembly by
reinstalling two (2) 5/16-18 bolts from Step 7.
Assemble discharge adapter to discharge bracket by
installing two (2) nuts (item 8) and two (2) washers
(item 9).
8.
Install vent support bracket (item 4) to dispenser base
with two (2) 5/16-18 bolts (item 5) and two (2) 5/16
lock washers (item 6). Install U-bolt to vent support
bracket with supplied 5/16-18 nuts.
9.
Install grommet (item 3) in right side panel.
10. Install new right side panel (item 2) with 1/4-20 nuts
from Step 5.
11. Reinstall the dispenser top cover and door panels by
following Steps 4 through 1.