Gasboy Vapor Assist User Manual
Page 2
032170 Rev. 8279
Page 2
Step 13
Step 14
Step 15
Step 11
& 12
Steps 10
Mounting External Vapor Pump
10. Remove plastic plug (vapor connection opening) from side panel.
11. Refer to template (032169) for instructions on marking and drilling
two 5/16” diameter holes through both side panel and side frame.
12. Replace plastic plug removed in Step 10 with rubber grommet
(028930).
Mount the Pump to the Dispenser
13. Position the OPW pump up to the dispenser. Align the vapor connection
of the OPW pumping unit with the side panel vapor opening. Insert set
screws through mounting holes. From inside the dispenser, place
Gasboy metal plate (045802) over the screws and tighten locking nuts
onto screws.
Install Jumper Hose
14. Using pipe thread compound, thread product jumper hose onto
90° elbow. Tighten with crescent wrench.
15.
Using pipe thread compound, assemble jumper
hose/bushing/swivel assembly to existing dispenser discharge
and tighten.