Gasboy 9800A - Manual (Page 3)

032092 Rev. 2008 Page 3
INSTRUCTIONS FOR KITS 032778, 032777
1. Remove existing hardware from window-totalizer.
2. Install new totalizer bracket with existing
hardware.
3. Install cable assembly with spirol pin to existing
totalizer.
4. Install other end of cable assembly (with larger
mounting hole) to existing meter with cotter pin.
5. Attach 0M0042 tie-wrap around plastic cable
cover and through odometer bracket.
6. Attach cable to pulser conduit using C08126 tie-
wrap as shown. For kit 032777 (see Fig. 3)
attach cable to conduit from DC junction box
rather than pulser conduit. Important: Allow
some slack in the cable (at the meter end) to
prevent excessive stress and premature
breakage during operation. Loop should be
gradual with no less than a 6" radius.
Figure 3: 9850A/2650A Models