Gasboy 215A - Manual (Page 2)

032138 Rev 1212 Page 2
Mount Hose to Retriever
1. Lubricate the new inverted hose threads and O-rings with a lithium-based grease and thread the hose onto
the pump. Tighten the hose/pump connection. Do not use pipe thread compound or Teflon tape on hose
connection.
2. With white grease, lubricate the threads on the opposite end of the hose and install the breakaway.
Lubricate and thread the second section on the hose into the breakaway.
3. Thread nozzle onto the hose and tighten. NOTE: For additional installation information, refer to specific
procedures supplied with the breakaway and nozzle.
4. Assemble clamp to hose and position so that hose does not touch ground when nozzle is hung in nozzle
boot. Pull out hose and check operation of the retriever and the orientation of the nozzle.
Stop