Gasboy 8700Q Series - Manual (Page 40)

GASBOY Series 8700Q
6-4 07/15/03
CHANGING THE PRICE
1. Unlock and remove the front panel. Repeat this
procedure for the other side.
2. The variator section of the computer register(s) is
exposed to allow for price changes. Slide the
variator cover of the computer register apart to
expose the price range arms.
3. There are 3 range arms located in the
variator section. One sets the tenths of a
cent position, one sets the one cent
position and the last one sets the ten
cents position. To change a setting,
grasp a range arm and raise it to clear the
range arm locator, and relocate the range
arm to the desired setting. Assure the
range arm is totally bottomed on its
setting. Repeat this for all range arm
settings if necessary.
4. To change the dollar setting, locate the lever control
which is located above the variator section on the same
level as the price display. There are 3 available
positions: 0.00, 1.00, 2.00. Remove the cotter pin,
grasp the lever and raise it slightly to clear the position
locators. Position the lever to the desired setting and
release. Reinsert the cotter pin through the lever and
plate. Note - If the lever will not move to the desired
position, rotate the right hand money wheel until the
lever is free to move.