High hose retriever overview – Gasboy 9800A User Manual
Page 2
032114 Rev. 8243
Page 2
Mounting Hose to Retriever
10. Lubricate the new inverted hose threads and O-rings with a white lithium based grease and thread the hose
onto the pump. Tighten the hose/pump connection. Do not use pipe thread compound or Teflon tape on hose
connection.
11. With white grease, lubricate the threads on the opposite end of the hose and install the breakaway. Lubricate
and thread the second section of the hose into the breakaway.
12. Thread nozzle onto the hose and tighten. NOTE: For additional installation instructions, refer to specific
procedures supplied with the breakaway and nozzle.
13. Assemble clamp to hose and position so that hose does not touch ground when nozzle is hung in nozzle boot.
Pull out hose and check operation of the retriever and lay of hose.
HIGH HOSE RETRIEVER OVERVIEW
Stop
Start