GAI-Tronics 300 Series RED ALERT Emergency Telephone Manual - Manual (Page 32)

P UB . 42004-438K
300 S ERIES E MERGENCY T ELEPHONE M ANUAL P AGE
30 of 45
f:\standard ioms - current release\42004 instr. manuals\42004-438k.doc
01/15
Standard Mode Programming
Prior to programming the RED ALERT ® Telephones read the “Programming” section in its entirety,
record the desired key sequences and jumper settings in the “User Settings” sections of Table 3 on page
22 and Table 13 on page 40, and then complete the programming as specified.
This “Programming” section has been divided into two distinct subsections; “Standard Mode” and
“SMART Mode.” Standard Mode programming is used if the telephone system installation does not
include the TMA (Telephone Management Application) PC software. With TMA installed, the
telephones will be monitored and the SMART Mode programming should be used. Normal telephone
operation is identical in either mode of operation.
Each RED ALERT ® Telephone is factory-programmed to receive Standard Mode commands. Factory-
default settings are shown in Table 13 on page 40.
Set-up Sequence
Set up each RED ALERT ® Emergency Telephone for either “remote” access programming or for “local”
access programming (keypad required).
Remote
Using a touch-tone telephone, call the RED ALERT ® Emergency Telephone. The emergency telephone
will automatically answer the call and generate a splash tone (low to high sequence), followed by a
success tone (short beep).
Local
Refer to Figure 23.
1. RED ALERT ® Telephones that do not include an integral keypad will require the use of a No. 51035-
011 Keypad and No. 61504-048 Keypad Cable Assembly. The keypad and cable must be connected
to J13 on the PCBA.
2. The CALL push button connector J1 is exclusively used for local programming. RED ALERT ®
telephones that include only the HELP push button must temporarily have the associated switch
harness plug moved from the HELP connector J7 to the CALL push button connector J1 on the PCBA.
3. Press the CALL or HELP push button (whichever is connected to J1). When dial tone is heard from
the speaker, simultaneously press the “1” and “#” keypad buttons. The RED ALERT ® Telephone
will generate a splash tone (low to high sequence), followed by a success tone (short beep).