beautypg.com

Foxconn 865M06-G-6EKS User Manual

Page 68

background image

Chapter 3 BIOS Description

60

865M06 Series User Manual

will close, however, the vertical and horizontal scanning movement of the screen
continues. When you select the “V/H SYNC + Blank” mode the vertical and hori-
zontal scanning movement of screen stops when the computer enters power
saving mode. “DPMS” mode is a new screen power management system, and
it needs to be supported by the monitor you’re using.

Video Off In Suspend (Default: Yes)
This option is used to determine whether the video is turned off when the
system enters sleep mode. The setting values are No and Yes.

Suspend Type (Default: Stop Grant)
This option is used to set sleep mode. The setting values are Stop Grant
(saves the status of the whole system and then turns off power), and PwrOn
Suspend (CPU and core system go to low power mode, keeps power supply).

MODEM Use IRQ (Default: 3)
This option is used to set the IRQ in which the modem can use. The system
will automatically wake up when the modem receives an incoming call. In
order for this function to work, the Fax/Modem must be connected to the WOM

header on the motherboard.

Suspend Mode (Default: Disabled)
This option is used to set the idle time before the system enters into sleep
status. The setting values are Disabled and 1 Min-1 hour.

HDD Power Down (Default: Disabled)
This option is used to turn off hard disk power if the hard disk is idle for a given

period of time. The setting values are Disabled and 1 Min-15 Min.

Soft-Off by PWR-BTTN (Default: Instant-Off)
This option is used to set the power down method. This function is only valid
for systems using an ATX power supply.
When “Instant-Off” is selected, press the power switch to immediately turn off
power. When “Delay 4 Sec.” is selected, press and hold the power button

for four seconds to turn off power.

CPU THRM-Throttling (Default: 50.0%)
This option is used to specify the CPU speed (at percentage) to slow down
the CPU when it reaches the predetermined overheat temperature. The
setting values are 75.0%, 50.0%, 25.0%, .